Answer / pralay kumar jana

In two transmitter, power-supply is provided through two
wires and signal also returns through the same wire.

But in case of four wire transmitter, power-supply is
provided through two wires, while signal returns through two
other wires.

Answer / george s

In the two wire transmitter one wire shall be the power
wire and the other wire will be the return wire(4-20mA)

Where as in the 4 wire transmitter (2 wires for power
supply and the other two for the 4-20 mA output)

Answer / aravind

in 2 wire X'mtr we are following wheatson bridge method ,so it need only 2 wire but in 4 wire x'mtr we following induction method like limit switch so its need 4 wire

what is the working principle of dis-placer type level transmitter

1 Answers   Sendan,

---

what are the problem's will accure in dcs or plc hadware and what are the solution for it?

2 Answers  

---

what is SIL 1 2 3

0 Answers   KOC,

---

what is control valve and how is work

5 Answers   Descon,

---

How to rerange a dp type level transmitter after installation?

1 Answers   NSH,

---

can you tell me how many stages in steam turbine of 10 MW power plant

2 Answers  

---

why the discharge pressure of ID fan showing negative at fan running condition.(boiler operating condition.)

5 Answers  

---

How to connect field devices to PLC and DCS using a FIELD BUS, DP,MOD BUS(please tell me any extra interfce or adopters need in this case if we use remote i/o s)

3 Answers  

---

what is maximum vaccume?

4 Answers  

---

why we use by pas on a positioner? When can a by pass be not used on a positioner ?

2 Answers  

---

Why 4ma - 20ma signal used in instrumentation??

5 Answers  

---

what is different between modbus and serial link? please could anybody give right answer.

2 Answers  

---