I am going to attend a recruitment drive by Schneider in 2 weeks. They have a

I am going to attend a recruitment drive by Schneider in 2
weeks. They have a technical test in the beginning. I would
like to know what are the areas i should concentrate on
while preparing for the test. My major is Electronics and
Instrumentation.

Question Posted / parvathy

1 Answers
4298 Views
I also Faced
E-Mail Answers

I am going to attend a recruitment drive by Schneider in 2 weeks. They have a technical test in th..

Answer / kumar

First of all schneider base of Electrical Company . better u
can concentrate in electrical and electronics .

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

how to calibrate steam control valve in steam turbine

0 Answers

Where should we terminate the shield and why?

3 Answers OPaL,

How to calibrate and check thermal mass flow meter of Make thermal instrument company inc model 60?

1 Answers Wood Group,

I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.

0 Answers

why 4 to 20 ma used at 0 set

2 Answers Borouge, Yokogawa,

where using the 0-20ma in feiled instrumentation? why its using?

4 Answers

what are the steps to follow force a particular input or out put from ics triplex esd system?

1 Answers

How to calibrate the pressure Transmitters

1 Answers

I want condensate pots vent position erection of flow transmitter ?

1 Answers

I have transmitter of range -20 to -5 kpa.if it is possible to zero trim with atmospheric pressure,means HP and lp having no pressure...what will get after zero trim and it is the right way.....plz give me reply ....

3 Answers KOC,

Controller not working in auto mode?...what are the problem can occur...Pls explain

1 Answers Aramco,

how will you segregate the alarm levels in alarm management system during factory Acceptance Test

0 Answers

For more Instrumentation Interview Questions Click Here