Answer / sandip

resistance temperature detector

Answer / ayaz

RTD is stand for resistance temperature detector
and use for temperature measurement it sense the temperature and output in resistance 

Answer / kunal

Resistance Temperature Detector

Input sense temperature and output is given as OHMS.

raw material MOC is platinum,nical,chromal.

for more more accuracy PT1000 mostly used.

temperature sensing range is -200* to 400*c.

with good accuracy.

Answer / guest

rajisant temprchar ditetar

How can I make calculation for Install level transmitter (DP) for open tank and cloes tank?

1 Answers   Petrofac,

---

Emergency Shutdown Systems/ Plant Shutdown System.

0 Answers   CCIE,

---

I HAVE PRESSURE TRANSMITTER WITH TWO WIRES 24 VOLTS SUPPLY.IF TRANSMITTER WILL GIVE SIGNAL TO THE DCS WHAT HAPPEN TO THE 24 VOLTS POWER SUPPLY IT WILL DROP OR REMAIN TO 24 VOLTS POWER SUPPLY.

3 Answers  

---

we are used SAMSON 3730 Smart positioner.please tell me how to calibration this.

1 Answers   TCCL,

---

why we use 24v dc in instrument rahter than 230vac????

4 Answers  

---

A pressure differential gauge type of instrument has a manifold with 2 isolation valves (hp and lp),2 vents(1 each for hp and lp) and 1 equalizing valve. Determine the position of each valve(either fully closed or fully open) when troboulshooting to: 1. zero the transmitter. 2. determine if there is a block in the impulse line. 3. determine if the gauge is functioning properly. The process fluid is water.

1 Answers  

---

Difference between guide wave radar & non guide wave radar ?

1 Answers   UPL,

---

How can corrosion alter the accuracy and precision of a C- Bourdon tube pressure gauge?

1 Answers  

---

how to calibrate a control valve?

7 Answers   Reliance, Telecon Systems,

---

Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.pls help me

1 Answers   Worley Parsons,

---

What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.

0 Answers   TNPL,

---

Explain Three way boiler.

2 Answers   L&T,

---