1.what is the basic difference between surge arrestor and
lightning arrestor and where we use it.
1.what is the difference between metal oxide without gapped
lightning arrestor and with gapped lightning arrestor
Answers were Sorted based on User's Feedback
Answer / v.sugumar- kurinjipadi-cuddalo
surge arrestor installed in indoor application like SWG
panel, HT motor termination box and etc..Lighning arrestor
installed in out door,example: top of building,and it is
connected to earth, incase of lighting air terminal will be
atracted by lightning and it is grounded.
Surge arrester installed in the power line, incase of hi-
sugre in the line, surge arrester (MOV) metal oxide
verister will conduct to the ground, and it will return
back to normal state. MOV during normal state the
resistance is high, when the surge incresed above the
certain limt it wil reduce the resistance.
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / eee
surge arrestor: these are capacitive/ solid state devices
which prevents sudden rise in voltage (max 2Vrated)
lightning arrestors: these are nonlinear elements, provides
high impedance in normal working, very low impedance at very
high voltage (lightning)....
withgap metal oxide will have higher voltage carrying
capacity. then the without gap MO.....
Is This Answer Correct ? | 3 Yes | 1 No |
what is the difference between relay and a contactor.
Is C.T will sense the current in both direction. As i know the C.T will sense the current in only one direction.
Which test will be more severe for VCB?
To generate electricity , what is the speed of rotor?
What is Star Delta Connection, where it is applied & what for it is used
4 Answers Premium Transmission,
what's the thickness of 1.5sqmm wire
Essential condition for parallel operation of two single phase transformer is that they should have same A polarity B kVA rating C voltage ratio D % impedance
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
why we are 0.8 power factor only?
what is is the potential diffrence between two phase ?
what are the different pre- commissioning tests performed on distribution transformer, power cable and switchgear?????
how much test voltage should applied for tan delta test.