Answer / yaswanth kumar

for 90 degrees bend the formula will be 8 times of the dia
of bar and for 180 degrees bend it will be the 16 times of
the dia of the bar to be added to the total length of the
stirrup.

Answer / umair naqvi

180=(4d),90=(12d)135=(8d) all dimension in mm

Answer / mufajjal ujjainwala

For 135 degree bend 10*dia of bar or 75mm min.

Can inverted beams used in pipes during construction?

0 Answers  

---

1) what do you mean by rolling margin of steel ? 2)pls. tell the cut length formula of stirrups as per IS codes(take out cut length for a beam of 600*300mm with 40mm cover all sides)? 3)what is the multiplying factor of painting for sand faced plaster? 4)if your footing is of size1.9*1.6m . what quantity of length and width you will excavate means what extra margins you will allow as per IS codes in billing?

1 Answers  

---

What is the calculation for finding cement and sand for 10' * 12' area ratio 1:6 thickness 12 mm

3 Answers   DLF, JVS,

---

Does vetrified tiles needs to be cure before fixing?

2 Answers  

---

Design an underground tank of internal dimensions 6m x 3m x 3m. The soil surrounding the tank always remains dry. The tank shall be provided with a roof slab. The soil weighs 16000 N/m3 having an angle of repose of 30.

0 Answers  

---

---

why seismic analysis not done during design of slabs

3 Answers  

---

WHAT IS THE RATIO OF CEMENT:SAND:COARSE AGGREGADE IN M-20, M-25, M-30, M-35, M-40, M-45, M-50 CONCRETE?

2 Answers   L&T,

---

what is the procedure for flakiness and elongation index

1 Answers  

---

What is thickness of RC hume pipes of size, 300mm, 450mm,600mm

1 Answers   L&T,

---

Which stone is best for wall construction Laterite Stone or Cement Blocks

0 Answers  

---

How many bricks will be fit in one cubic meter, if the brick measurement is 0.20cm X0.08, If you also write down the formula for this question too.

3 Answers   Vardhman,

---

The Hinged and Roller support is same or differnt if it is differnt how does it differs

3 Answers   HCL,

---