How receiver detect that which is information signal and which is carrier sign

How receiver detect that which is information signal and
which is carrier signal and how it seprate both at
destination?

Question Posted / sahil baghla

4 Answers
7254 Views
Airtel, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How receiver detect that which is information signal and which is carrier signal and how it seprat..

Answer / rakesh

since the work of demodulator is to demodulate high frequency carrier signal,so in its recovery circuit it employs a circuit which does not allow high frequency signals to pass , but passes the low frequency signal.
where the high frequency is carrier signal & information being the lower frequency .( According to the definition of Modulation)

Is This Answer Correct ?

8 Yes

0 No

How receiver detect that which is information signal and which is carrier signal and how it seprat..

Answer / farhan

the demodulation is to ckeck tha singal through phase &
frequecey of the singal and the low pass filter reject the
high frequncy singal

Is This Answer Correct ?

3 Yes

0 No

How receiver detect that which is information signal and which is carrier signal and how it seprat..

Answer / r.jayashankar

Demodulator at the receiver will separate carrier and
message signal..

Is This Answer Correct ?

3 Yes

1 No

How receiver detect that which is information signal and which is carrier signal and how it seprat..

Answer / parth

There are different technique employed for the detection of the modulated wave so for AM wave or other the envelope detector is used that separate the carrier from the modulating signal by using diode

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

Mention some of the applications of controlled rectifier?

0 Answers

When an RC driving point impedance function has zeros at s=-2 & s=-3,then admissible poles for the function would be? a)s=0;s=-6 b)s=0;s=-3 c)s=0;s=-1 d)s=-3;s=-4

3 Answers BSNL, Jindal Steel and Power,

what is work of eoca card in nokia flexi EDGE BTS?

0 Answers Ericsson,

hi i am electronics & telecomm engg & appling 4 the AAI jr executive (electronics/ATC) written test. pls forward me the syllabus & old question papers.I will be very much thankful to you. pis inform to mpnisi@gmail.com

0 Answers AAI Airports Authority Of India,

what is modem

5 Answers HCL,

diff between AMD64 and intel P4

0 Answers AMD,

How the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?

0 Answers

why we most prefer negative clock input(negative level) most in all flip flop answer

3 Answers

why should i hire u?

4 Answers Wipro,

In a bipolar junction transistor (take it an n-p-n BJT),,in comparison between EMITTER and COLLECTOR ,,who has higher negativity??

3 Answers

difference btwn channel and carrier in telecom?

0 Answers

Telecom BSS related ques: For cascaded 1800 BTS with master 900 BTS,if 900 master BTS is down for its own equipment fault,cascaded slave 1800 BTS gets down/stop carrying traffic without any fault as BCCH and other controllong channels are in master 900 BTS.Is there any technology/system to turn the slave 1800 BTS to a single 1800 BTS autometcally when 900 master BTS is down for its own equipment fault???It is possible to make the slave 1800 BTS single live BTS manually.But I want to know the autometic system/process.if there is any....if not available, how can we generate the system??

3 Answers Ericsson, Grameen Phone, Nokia, TATA, Telecom,

For more Electronics Communications Interview Questions Click Here