Answer / pillay

You can have the frequency at any frequency you like,
but than you must also make your own motors, transformers
or any other equipment you want to use.We maintain the
frequency at 50hz or 60hz cos the world maintains a standard
at 50 /60hz and the equipments are are made to operate at
these frequency.

Answer / kalidhas

50 Hz frequency is the indian standard maintained in power
sysytem so that all electrical eqquipments are designed in
at this Frequency.Otherwise not other reasons..

Answer / ashhad khan

first of all the reason for choosing 50 Hz or 60 Hz frequency is to minimize the loses as well as transmit power efficiently . So if we try to use 100 Hz as a frequency of our power supply it will result in to many many loses like core losses will increase drastically moreover we will require a better quality core and there are many other loses which are not accounted generally in theory problems but practically they are accounted like with more frequency there will be more interference in telecommunication lines passing near to power lines and it will induce emf in every iron part near to power lines including supporting towers.

And when we talk to drop our power supply frequency to low levels like 20 Hz or 30 Hz it again results in power loss and inefficient transmission . as with lower frequency biggest concern is noticeable flickers in lamps . Thus considering all we use 50 or 60 HZ supply.

1. If we apply dc supply to the primary winding of transformer it will be burnt out. similarly dc supply is given to field winding of syn. motor and armature winding of dc motor, they are safe. (Remember both windings inductive nature) what is the reason behind that?

2 Answers  

---

what is electric current

17 Answers  

---

why near the transformers, the Jelly(small white colored rocks)are poured.and what are conditions for that?

3 Answers  

---

What type of DC motor would you see for a lift?

0 Answers   Ericsson,

---

what is earthing.how we make it,describe briefly.

0 Answers   HAL,

---

11. As per the theory current doesn’t flows in Neutral, but practically it is not applicable, explain why? 12. How to take the Vector Group Test in Transformer? What is the purpose of doing Vector Group Test? 13. Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV, 20kV, 30kV? 14. Why do we generate 3 Phase AC Supply? It is possible to generate 4 Phase and 5 Phase explain it? 15. Explain why the Voltage drop will happen in 3 Phase line? 16. What is the equipment used to control the generator output? 17. What are the factors to be considered during the Synchronization? 18. What should be value of Circuit breaker operating time and tripping time? 19. Why the CT Secondary is rated as 5A generally? 20. At which time Synchronous generator act as a Synchronous Condenser?

1 Answers  

---

what the purpose of data retrivala panel in substation

1 Answers   NCC,

---

220/33kv voltage level having 60MVA rating , which transformer is preferred two winding or auto transformer. why, kindly provide your strong technical valuable views.

1 Answers  

---

why there is a phase difference between line voltage & phase voltage ?

4 Answers  

---

wath is this mining of bts

1 Answers   Nokia, TATA,

---

Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics

0 Answers  

---

What is maximum load capacity of 800 VA inverter?

5 Answers  

---