why should be the frequency is 50 hz only why not others
like 45, 95 56 or anything ,
why should we maintain the frequency constant
if so why it is only 50
Answer Posted / kalidhas
50 Hz frequency is the indian standard maintained in power
sysytem so that all electrical eqquipments are designed in
at this Frequency.Otherwise not other reasons..
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
Earth bits close or open. Which is correct
What is the name of the winding from which the supply is taken for load connections?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is transformation ratio what it describes?
What current flows in the transformer primary when its secondary is open?
What is DTR erection?
1.what is difference between ATS & STS main use. 2.what is difference between ACB& VCB With symobles,and main partes, manimum range. 3.How many types of relays and main function.
how many joint can done in HT line and what is life of the joint
exolain the star delta connection
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
State superposition theorem?
How to decide and select the different earthing wire size for the different types of earthing
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
what is the formula for hv test for cable and circuit breaker..????