Answer / vshnu

that is l.v side,
at h.v side current is less and voltage is high
but l.v side voltage is less and currents is high
in order to get current rated we have to short circuit the l.v terminals by applying less than rated voltage at h.v side.
the small amount of voltage at h.v side is enough to produce rated current at l.v side so that test is conducted on l.v side only,
the small amount of voltage at l.v side not able to produce
rated current at h.v so we are not short circuiting h.v side
refer p.s bimbra book

short notes on npn & pnp transisitor..........

5 Answers  

---

How CT is connected to measure current by changing plug setting , ratio is 300 - 150 / 5 A ?

1 Answers   Ajanta Pharma, Bhel, Cosmo Films, Suzlon,

---

Hi all, please could anybody give me a suggestion about Electrical designs and calculations .. what text book should i follow as i am a trainee engineer and here work going not so favorable to me so please help me friends .. A small discription about my work which is going here is all about Electrical designs like cable sizing, lighting, lightning, Gensets sizing, motor sizing, transformer sizing, generator sizing, circuit breakers, PDB MCC PCC SLDB MLDB panels, Single line diagrams mainly, substation desings, cable routing and layouts, reactive power compensations, power factor improvement, voltage drop calculations, power generations, power transmission, power distributions all calculations i need .. please please if anybody experienced with this problem and got a solution then please help me .. just i need an apt text book for these all calculations and designs ..

0 Answers  

---

A d.c. Shunt motor is found suitable to drive fans because they require?

0 Answers  

---

which seven wonders are selected in india in 2008-2009

2 Answers  

---

---

WHICH IS BETTER( FOR POWER SAVING)- ON LINE OR OFF LINE UPS ?

3 Answers   Punjab National Bank,

---

How to decide the fuse ratings for potential transformer

2 Answers   Eskom,

---

What is difference between insulating medium and fault current interruption medium in a switching device.

0 Answers  

---

why we not use capcitor in Three phase motor ??

2 Answers   GOMS, Power Electronics,

---

Why Parallel operation of two Transformer are Required?

6 Answers  

---

WHY WE CAN GENERATE POWER IN 3PHASE MODE ONLY NOT IN 4 OR 5 PHASE?

10 Answers  

---

What is slip in an induction motor?

0 Answers  

---