why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT
CHANGES ACCORDING TO FARADAYS LAW.
No Answer is Posted For this Question
Be the First to Post Answer
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
At what speed an electric car can run with 2 HP motor of weighing 400 kg?
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
is there any current flows in our body?
how the earthing point or earthing is taken for ships and airplanes?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
In a synchronous machine if the field axis is ahead of the armature field axis then the machine is ?
what is allowable current flows from phase to ground with out tripping the breaker
why we used capacitor in induction motor?
how to modify DOL control panel into Delta Y connection?
IN HT MOTOR HT REFERS TO HIGH TENSION OR HIGH TRANSMISSION?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)