Please clarify, 1. Is it

Please clarify,
1. Is it required to lay two runs of GI wire along
with Armoured LT cable if it is laid between one big mains
(63Amps TPN SDF) to small main (32A TPN SDF) with proper
glanding termination?
2. If the armoured cable with proper glanding is laid from
DB to CNC machine, is it required to run two runs of body
earthing to the Machine from DB?
3.If the armoured cable with proper glanding is laid
from Substation to Hangar, distance is approx. 100 mtrs, is
it required to do earthing at shop area though the primary
termination at substation is earthed through gland.

Question Posted / sreenu

0 Answers
1988 Views
HAL, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..

0 Answers ME,

We have a 62.5 KVA DG with Leyland engine and kirloskar slipring alternator. We have earthed the neutral, and another earthing for the dg body. is it necessary to isolate the dg foundation with rubber pads?

1 Answers

What type of surgery impedence with 200ohs

1 Answers

how to check avr of dg set of 125kva

0 Answers

In which working principal temperature transmitter work.explain in detailed.

0 Answers

for 750 kw LT load what will be the ht kva

0 Answers Sterling Tools,

HOW TO DRAW THE VECTOR DIAGRAMS OF A Dyn 11,YdN 1 transformers?

0 Answers

Explain the power rating of a bulb, say 60W, what if the voltage changes

4 Answers

Differance between power circuit and control circuit

3 Answers

What is dynamo function in DG sets and draw block diagram?

0 Answers KPR Agrochem,

what must be the mf for a meter with the following conditions. line ct ratio-100/1 line pt ratio- 220kv/110v meter pt ratio- 3X63.5V meter CT ratio- -/1 A

1 Answers

what is the difference between LATCH and FLIP FLOP

4 Answers Wipro,

For more Electrical Engineering Interview Questions Click Here