why we used capacitor in induction motor?
Answers were Sorted based on User's Feedback
Answer / m s kumar
Since induction motors have inherently low power factor,
Capacitors are used to improve the power factor. In
fractional hp motors, they are used in the starting winding
to temporarily convert the motor into 2ph motor to make it
self starting
| Is This Answer Correct ? | 28 Yes | 0 No |
Answer / gunasekaran
To improve the power factor of the motor. motor is inductive
load it draw reactive power from system.so we have
compensate the reactive power component from capacitor.for
single phase motor capacitor used for stating purpose
also.and single phase motor are low power factor motor
because due to large air gap B/W stator and rotor so it draw
more current from system.so capacitor are use in induction
motor
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / manish
To run the motor,stating torque and current needs to start
the motor and this capacitor work as residual magnetesim
for the motor at stating point.
| Is This Answer Correct ? | 0 Yes | 0 No |
why we are grounding the neutral?
if the stetor speed (N S) increase by 20% then the rotor speed will be increased by 20% is it true. ?
what is different between earthing and grounding for a electrical eqipment ?
2 Answers BARC, Omega Maritime,
Why 36 KV LA is used in 33 KV Line and 9 KV LA is Used in 11 KV Line
1 Answers APTransco, Bhel, Wipro,
Specify the crystal frequency required for an 8085 system to operate at 1.1MHz
How much the fault level of 11 k.v.,22 k.v., 33 k.v. (in Maharashtra- M.S.E.D.C.L) for calculation of short circuit current & selection of h.t.cable.
what is the advantages of Lighting transformer?.. is it possible to reduce the power consumption ?.
How can I known multiplying factor .without multiplying table
what is function and advantage of double delta winding in induction generator?
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
can we find the inductance of a induction motor?
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
0 Answers Bhel, Jai Balaji, Rashmi Group,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)