Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will
be the effect if secondary is used for earthed system.
No Answer is Posted For this Question
Be the First to Post Answer
What should be the dielectric strenght value of transformer oil of 11/0.433KV distribution transformer and 33/11KV tranmission transformer ?
if we want to increase the back up time of an UPS what should we do ? if we want to decrease the charging time of a battery/batteries attached with the UPS what should we do ?
how to calculate efficiency of voltage and current controlled welding transformer?
why celing fan is running in anti clock wise and table fan is running in clock wised?
2 Answers Ambuja, Infosys, MAHINDRA,
in 3-phase transformer which type of transformet is used in output side?
How many 2 ton window A/c can runs on a 125 KVA generator?
what about the input current fan when regulator regulates to speed low?
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
what is the right cable size for 100 hp mpter.
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
which pole motor is best ?4 pole motor or 6 pole motor,why?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?