Answer / kundan malani

bcz the voltage measured in the line to ground and ground is
the reference's so that the PT Primary are the grounded.

Answer / p.k patel

voltage is measerd from line to grond and another reason if any fault occur at primary it will flow through the ground and equipment will protected

Answer / soumik biswas

We all know CT secondary should be grounded but why not PT secondary?

Answer / munish

PT is instrument and it is single phase T/F.it is working
on mutual induction.so it take neutral from ground.hence PT
primary is grounded.

Answer / o.p.arya

PT primary winding has delta connection and secondary in star
so delta winding how is possible to grounding always star
winding grounded to measure the voltage phase to phase &
phase to ground or neutral.

Where is servomechanism used?

0 Answers  

IN SOME CASE, WHEN I GIVE 24VOLTS DC AS INPUT, WHILE IN OUTPUT (THAT MEANS TERMINAL SIDE OF THE INSRUMENTS) I,M RECEIVING ONLY 6 VOLTS, WHAT IS THE REASON FOR THAT MUCH VOLTAGE DROP?

3 Answers  

what are the merits and demerits of synchronous motor over an induction motor...??

5 Answers   NTPC,

Application wise, where we should use AC motors and where we should DC motors?

1 Answers   Nespak,

what is the function of potential transformer in s/s

6 Answers  

On load tap changer (OLTC) explode? Transformer Vector group: Ynd11 Rated Power: 353MVA Rated Current: 693A Voltage:294/20KV OLTC Type: T III Y1000 110/c 12193w Max Operation Current: 295A Step Voltage: 550V Arrangement in Tx windings: Y Connection Problem: Damage of Unit 1 Generator Transformer On Load Tap Changer (OLTC) Description of Incident: 9.00 a.m. :- Generator No Load test on excitation system started 10.30 a.m :- Carried out AVR change over test 11.30 a.m :- Preparation for Generator Manual Synchronizing test 12.00 a.m :- Manual Synshronizing test started. Observed incoming generator voltage higher than running voltage. CECR operator operated Generator Transformer OLTC to bring down the incoming generator voltage 12.03 a.m :-Generator Transformer abnormal alarm operated at Gen.Control Desk (CECR) CECR operater at Generator transformer bay informed that the transformer oil splashed out from OLTC. CECR operater informed that he heard explosion inside OLTC. Observed Oil level & Oil Flow alaram operated at Tranformer local annunciator. 12.05 am :- CECR operator 'Open Gen Field Breaker” 12.10 a.m. :- Elec1 team inspected the OLTC and found the OLTC rupture disk was broken and oil spilled at OLTC area. - Elec1 found the OLTC top cover bulging. Do anyone know why and possibility cause happen in this OLTC.

9 Answers  

how will we calculate the copper wire load..

0 Answers  

Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.

0 Answers  

What is the technical name of Transformer Oil ?

17 Answers   Bhel, Don Bosco, Lanco,

how air lock will be removed from generators, how it happens?

1 Answers   ABC Engineering,

what is the difference between mho characteristics and quadrilateral chara in distance protection

1 Answers   Essar,

Why pmg used in electrical generators for excitation.is there any other method without pmg ?

1 Answers