In most process, speed of motor controlled by control system with a reference

In most process, speed of motor controlled by control
system with a reference pot . Now if i start & it becomes
uncontrollable, i.e.gets directly start & stop after certain
time.Then which reasons can make such problem? can motor
may be faulty?how?

Question Posted / aygunjal

3 Answers
6335 Views
Siemens, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In most process, speed of motor controlled by control system with a reference pot . Now if i star..

Answer / manraj meena

no. this problem is not related to motor,it may be due to
pot get faulty (variable point).thats why it run only
constant speed.

Is This Answer Correct ?

3 Yes

0 No

In most process, speed of motor controlled by control system with a reference pot . Now if i star..

Answer / amit

Actually There May be two Reasons Behind the problem
1)The baring of the motor can't bare that much of Voltage
at certain long time.
2)Change in Voltage Can Burn the Winding.

Is This Answer Correct ?

1 Yes

2 No

In most process, speed of motor controlled by control system with a reference pot . Now if i star..

Answer / an70n

faulty or defective tacho generator

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

Describe a time when you anticipated potential problems and developed preventive measures.

0 Answers Hotel Management,

whether radar level transmitter is applicable for the open tank

1 Answers TCL,

god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies

0 Answers

What is megering????

2 Answers

What is the difference bitween control net scaner and device net scaner

0 Answers Binani,

how to calculate the temp. of RTD&Thermocouple when we got some mV r Ohms?if anybody has d chart pls mail the chatrs to me...

1 Answers

in which mode of the zener diode act when load voltage is approximately constant

1 Answers

What the basic of communication?

4 Answers Schneider,

how do u calibrate the vacuum transmitter if it shows more reading

0 Answers

Hi Frnds , If Suppose 1 Pair cable of 1.5 sq mm is used for Transmitter and instead of 1.5 sq mm if i used 0.5 sq mm cable will the resistance change will occur and does it affect our transmitter reading. plz mail ur answer to ntnkamble@gmail.com plz immediately mail ur reply

1 Answers

Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plants instrumentation field , which one field is give long life & which one field is best ,I confused a lot And also I'm studying AMIE, can I choose which field from Section B examination?

1 Answers

why twisted pair of wires is used in instrumentation ?

6 Answers ONGC,

For more Instrumentation Interview Questions Click Here