Interested to Buy Any Domain ? << Click Here >> for more details...
In most process, speed of motor controlled by control
system with a reference pot . Now if i start & it becomes
uncontrollable, i.e.gets directly start & stop after certain
time.Then which reasons can make such problem? can motor
may be faulty?how?
- 3 Answers
- 6327 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / manraj meena
no. this problem is not related to motor,it may be due to
pot get faulty (variable point).thats why it run only
constant speed.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
what is the procedure of belt scale calibration?
how to commission furnace ( water heater)
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
What is 3 element control system
What is the reason PT speed not incresed in gas turbine?
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
in mass flow meter what is drive friquancy ?
Identification of ss fittings, pilot valves, relief valve.
How to calibrate an pressure gauge with yantrika test bench?
What is the procedure of calibration of Load cell?
