what is mean by process control?
Answers were Sorted based on User's Feedback
Answer / mohammad sikandar
process control means measuring and controling of process
veriable like
level,pressure,tempreture,flow,vibration,qantity this all
those measure and give to out put to finel control.
| Is This Answer Correct ? | 23 Yes | 3 No |
Answer / chandra prakash
process control means control of parameters
(pressure,temp,flow,level etc)essential for any process.
| Is This Answer Correct ? | 16 Yes | 3 No |
Answer / c.r.r.nair
Process control can be described as the method of keeping the process within the specified boundaries controlling and monitoring the variations to the least minimum to achieve the optimum quality product.
| Is This Answer Correct ? | 10 Yes | 1 No |
Answer / manraj meena
process control means air,temp.,flow control.which uses in
process.
| Is This Answer Correct ? | 10 Yes | 6 No |
Explain pH, Conductivity.
a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the accuracy ratio? is this ratio acceptable?
Can 2 transmitters be connected to Integral orifice meter taps? Does an integral orifice comes with 2 set of taps?
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
give me all the details about the interview and which type of question being asked
What is the meaning of wet leg
In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.
When LP SURGE happening in compressor
what is the zero and span trim?
what is the principal of coriolis mass flowmeter
what is the difference between RS 232,RS 485,RS 422, how they different from each other
What do you know about gail?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)