i have 20 kw motor & my vfd drive capcity is 18 kw if possible to use 20kw

i have 20 kw motor & my vfd drive capcity is 18 kw if
possible to use 20kw motor on this vfd?

Question Posted / mayur

4 Answers
10059 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

i have 20 kw motor & my vfd drive capcity is 18 kw if possible to use 20kw motor on this vfd?..

Answer / kritesh

No, we cant run the motor having capacity different from
drive as we have to do ID run before running in remote mode
and in that mode we have to feed the same parameter as motor
have.

Is This Answer Correct ?

3 Yes

1 No

i have 20 kw motor & my vfd drive capcity is 18 kw if possible to use 20kw motor on this vfd?..

Answer / sanjeev singh

yes we can run the motor on 90 % load.

Is This Answer Correct ?

1 Yes

0 No

i have 20 kw motor & my vfd drive capcity is 18 kw if possible to use 20kw motor on this vfd?..

Answer / alok ( bl agro)

yes we can use but have to set moter current value according to lower moter high curren

Is This Answer Correct ?

0 Yes

0 No

i have 20 kw motor & my vfd drive capcity is 18 kw if possible to use 20kw motor on this vfd?..

Answer / sk.raffique

U can Use The 18 kw drive no problem .U are using VFd to
Reduce Power u will not be running for 20 kw if U want to
Use More Than that u increase The Torque setting and torque
%. the problem will besolved .

Is This Answer Correct ?

2 Yes

4 No

Post New Answer

More Instrumentation Interview Questions

what is mean by process control?

4 Answers

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers EIT,

What is the deffernce bet. Instrumentation and Electrical Enginerring?

1 Answers

How to do gas analysers calibration in AUTO and Manually by using zero and span gas?

0 Answers

any body pl suggest me the best type of transmitter for level monitoring of a distillation still which consists of highly corrosive and inflammable liquid.closed vessel height=5000mm especially in petrochemical industries

1 Answers

what is the difference between -24 : +24 & 0:24 and where it use?

0 Answers

what do we mean by hook up drawing. what r the information we get from it?

7 Answers Reliance,

HOW THE ORIFICE & PRV SIZING BE HAPPENED -- EXPLAIN IN BRIEF

3 Answers

What is the purpose of valve positioner. Explain 4 uses.

2 Answers SRACO,

Describe the basis on which alarms should be generated and how their associated priority is determined

3 Answers

What's the difference between cold loop test and hot loop test?

5 Answers

how to calibrate steam control valve in steam turbine

0 Answers

For more Instrumentation Interview Questions Click Here