Answer / brijsh

it willbe increases

Answer / mojinkoshy

if load increases, the RPM of the DG set(engine & coupled generator) should maintain constant to make the electric frequency constant. In such a case to balance with the increase in load the engine should have to burn more fuel to maintain the same RPM (energy can nether be created nor be destroyed). Burning of more fuel means more heat produced.

what is the voltage and ampere rating of all range of HT conductor?

1 Answers  

---

Why is the air gap between the pole pieces and the armature kept very small?

0 Answers  

---

if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain

0 Answers   NCC,

---

1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??

0 Answers   ACC,

---

I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok

0 Answers  

---

what is the purpose of fuse?

7 Answers  

---

Electrical breakdown strength of an insulating material depends on............?why because?

2 Answers  

---

What is the generating voltage of a power station consided generally?

20 Answers   L&T,

---

why ct is testing using dc.. y cant we use AC insted of dc on POLARITY TEST.

6 Answers  

---

what happens if a carbon brush is touching the top end of the commutator

2 Answers  

---

Why do we mix soda with water in LRS?

1 Answers  

---

What are thermo couple cables and where they are used.

2 Answers  

---