Answer / dasharath waghmode

To check the continuity of a cable, first short any two cores of a cable at one end and test same cores for continuity on other end by megger. If both cores are open it will show high resistance and if not will show zero resistance. And repeat the same process for other cores.

Answer / sanjayjssate

its very simple
Connect the other ends of cable togather and take megger from other end at very low voltage, if megger is zero means it is continuty is one, again seprate the the cable and take the megger if megger is more tha 100 Kohm, means cable is healthy.

Answer / guest

we connect the megger to cable then read the megger reading. If this reading is infinity then your cable will ok. Or megger does not show infinity then your cable is cut or insulation level is decreased

Answer / k.prakashchandra

Do not check continuity with megger , use multi meter

what is the frequency of direct current(dc)?

12 Answers   Cognizant, University,

---

If rotor works in clock wise what happens

0 Answers  

---

what is power plant?

2 Answers  

---

what is apparant power and reactive power

2 Answers  

---

what is the chemical reaction of solt and charcoal in earthing?

1 Answers   Shyam Group,

---

Mention what are the types of semi-conductors?

0 Answers  

---

which strater used genearalyy???and why???

1 Answers  

---

Why DG set is not installed in Terrace ??

0 Answers  

---

How can we checked Killo Watts of Motor & Alternator?

0 Answers  

---

Hi How can you start-up the 40w tube lite with 230v AC/DC without using any choke/Coil.

5 Answers  

---

how to match 0 -10V with 4 - 20mA

3 Answers  

---

What happens if you give supply to the rotor of three phase induction motor?

11 Answers  

---