1. When do you use a VFD motor?
2. If the ceiling fan is on slow speed, does it consume less
electricity?
3. If we want the fan to consume less electricity at low
speed, what do we have to do?
4. What does “battery of 180 AMP HOUR” mean to you?
5. What does “battery of 180 AMP HOUR” mean to you?
6. If you don’t have coal, salt and copper, then how would
you earth your connection temporarily at a camp site.?
Answers were Sorted based on User's Feedback
Answer / mohankumar
question 1?
if fan needs variable speed then we use vfd .....
question 2?
no it consume same power .....
question6
just use a iron bar fixed in earth , then u use that as
earth or netural
| Is This Answer Correct ? | 7 Yes | 2 No |
Answer / prakash
Q - 1 VFD can be used where you need variable speed, like
Compressors.
Q - 2 & 3 - We cane make the ceiling fan consume less
electricity by usung electronics fan regulator.
Q 4 & 5 - For battry 180 AH means the backup power of
battery can provide energy to 180A load for one hour.
Q 6 - We can use spike earthing as well
| Is This Answer Correct ? | 4 Yes | 2 No |
Answer / b.veeranna
1.Variable Frequency Drive (VFD) to operate the fan at variable speed. Since you can operate the fan at any speed below its maximum, you can vary airflow by controlling the motor speed instead of the air outlet damper.You can divide the world of electronic motor drives into two categories: AC and DC. A motor drive controls the speed, torque, direction and resulting horsepower of a motor. A DC drive typically controls a shunt wound DC motor, which has separate armature and field circuits. AC drives control AC induction motors, and-like their DC counterparts-control speed, torque, and horsepower.
2.if regulator is electronic then it save electricity but if
regulator is resistance base then it doesn't save.If regulator is electronics
4.Battery rating (capacity) =180 AH
Battery capacity in ampere hour.
in normal condition ,dc current of 180 ampere for one hour.
it is product of load current x time (for which it can supply)
4.Small refrigerators range in size from around 1/2 ft^3 to several ft^3, so it's hard to say, but it won't be anywhere near the power consumed by a full-sized refrigerator/freezer. Maybe about 25% of the power or less as a rough guess.
The amount of power is published by the manufacturer in the product literature, and is also printed on the unit.
5.The rate at which the batter is discharged directly affects its capacity. If a battery is dischareged quickly less capacity is available. Conversely, a battery that is dischraged slowly will have a greater capacity. For example , a six volt battery may have a 180 AH capacity if discharged over 24 hrs. However if the same battery is discharged over 72 hrs it will have a 192 AH capacity.
6.Salt and coal are require to reduce the earth resistance
hence it may or may not required for all soil.
The copper is a one of the conductor ..If the copper is not
there we can use other alternative conductor such as steel
or aluminium
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / rupesh
we can make the fan to consume less electricity
| Is This Answer Correct ? | 10 Yes | 14 No |
what will happen when reverse reactive power occurs in alternators?
A resistance, inductance & capacitance are connected in series between points A & B.The voltage drops across the resistance,inductance&capacitance are found to be 40V,70V&100V respectively. What is the total voltage between between points A&B (Vab)? a)210V b)70V c)50V d)230V
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
Differentiate between Low and High impedance Protection
synchronous motor of 13.5MW having which type protection? and how to set relay?give me relay setting calculation for different protection for this motor assume efficiency,power factor and other term if neccecery
What is the si unit
in our sub station why we step down firstly 33kv\11kv then 11kv to 430v. can we direct step down 33v to 430.v.
What is vector group? What is meant by DYN11?Why is it needed?
13 Answers Areva, Bhel, BRG, Escorts, Fortis,
What are the industrial applications of Superhetrodyne Receivers ? What are merits & De-merits of SuperHeterodyne Receivers ?
what is difference b/w squirrel cage rotor and wound rotor
in 11kv/400v transformer when only one phase of 11kv supply fails what happens to sec voltage and why
what is the effect of leading power factor
3 Answers Aurobindo, R L Steels and Energy,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)