What is the difference between Gas Turbine and gas engine in Gas Power plant ?
Answers were Sorted based on User's Feedback
Answer / nasir
gas turbine is a prime mover which run the gas engine to
generate power.
| Is This Answer Correct ? | 46 Yes | 16 No |
Answer / sathya
Gas Turbine: converts pressure energy to kinetic energy and gets the rotational energy
Gas Engine: operates as internal combustion engine principle, mostly four stroke.
Both shall be used for power generation, even gas engines can be used in the combined cycle plant principle
| Is This Answer Correct ? | 12 Yes | 2 No |
Answer / harish devrani
In Gas Turbine Energy Conversion or we can say Generation takes place outside the unit whereas in case of Gas Engine Energy generation takes place within the unit.
| Is This Answer Correct ? | 6 Yes | 1 No |
Answer / amir mahat
Gas turbines is much bulky nd having a parts like
compressor,filter,condenser and the turbine itself...whras
gas engine is simple nd having only few parts. So the
thermal Efficiency of Gas Engine is greater than that of
the Turbine..
| Is This Answer Correct ? | 8 Yes | 9 No |
Answer / devanesan
Both are same. the output is kinetic energy from heat
energy.
| Is This Answer Correct ? | 4 Yes | 5 No |
Answer / baskaran
Gas turbine more than efficient gas engine. Gas turbine system have air compressor and combustion chambers.it is produced high velocity of hot gas but gas engine principle just like stroke system.
| Is This Answer Correct ? | 0 Yes | 2 No |
Answer / sharad
In gas power plant gas turbine is a prime mover using gas or
working fluids it generate power using these power it drives
gas engine.
| Is This Answer Correct ? | 8 Yes | 11 No |
Answer / vinayak mahajan
GAS TURBINE PRODUCE POWER &GAS ENGINE PROVIDE REQUIRE POWER
| Is This Answer Correct ? | 8 Yes | 12 No |
Answer / moshi naidu
Gas turbines are using Power generation and Gas engines are
using Automobiles.
| Is This Answer Correct ? | 10 Yes | 15 No |
Steam is a vapour or a gas ?
Explain the hooke`s coupling.
What are the 3 parts in indicator diagram?
I have a thermal flask in which i have to fill the boiled water. I also have thermocol, saw dust and silver paper. Now tell me how i have to arrange these material to attain minimum heat loss.
what is mechanical
4 Answers Lotte Pakistan PTA, TATA,
Wat is the accumulator & what is the function of it?
What happen when too much cylinder oil is injected in the working cylinder?
Which furnace burns low-ash fusion coal and retains most of the coal ash in the slag?
Distinguish between the shear center and elastic center.
c,c++,java,.net,php
Small gear found in the steam turbine.
0 Answers ABC Inc, RRB, Siemens,
1. Centrifugal pump is used to drain the coolant from the machine to coolant tank via magnetic separator and paper filter. But more foam is raising in the coolant tank. We need to arrest the foam formation inside tank which is nt desired. How do we correct this issue? (Hardness of the water is at recommended ppm).
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)