Answer / sjtbehera

splice length is recquired to transfer force from one bar
to another.
it is calculated in two ways
1. lap length in compression
2. lap length in tension
it is equal to development lenth that you can calculated
from book

Answer / divahar

splice length is calculated similar to lap length. It is based upon diameter of rod and grade of concrete.

Answer / ashwin sonwane

when the length of bar available in market is smaller or
when the pieces of bars are to be utilized the bars are
required to be lapped
a) flexural tension: Ld or 30dia,whichever greater
b) direct tension: 2Ld or 30dia, greater
c) compression:Ld or 24dia, greater

straight length of lap should not be less than 15dia or 200
mm, minimum

how much thick Pcc required for floor tiles

3 Answers   Vardhman,

---

In a beam tension is always at the bottom but sometimes when we design using staad we get more number of rebars at the top compression zone Why?

1 Answers  

---

How to calculate the quantity of cement,sand,aggregate for the area L*B*T are 15.24 m*21.36m*0.12m in the ratio 1:2:4 can any ine explain in detail by using formulas. Thanks in advance

2 Answers  

---

how can we design dia of rainwater pipes ? plez explain by using formula ?

1 Answers  

---

differance bet QA & Qc

1 Answers  

---

what is the formula of calculating number of bars?

3 Answers   Ameyas,

---

where you provide on column

5 Answers   ABB,

---

What is full form of r.c.c?

1 Answers  

---

how to calculate rate analysis for column shuttering

2 Answers   L&T, Marg,

---

difference between high way pavement and local road?

9 Answers   L&T,

---

on what basis the partial factor of safety are decided? form the load combinations

0 Answers  

---

what is the yield strength of M30 grade of concrete

2 Answers  

---