Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72

0 Answers  

---

Differentiate between PLC, SCADA and DCS systems

1 Answers   Mumias Sugar, SRF, Trimula Industries,

---

while stroke checking of a linear control valve ,found its travel is in non linear ,what can be possible reason ? ( please answer send in mannanali65@gmail.com) pls pls pls if any body know

2 Answers   JAL International,

---

Why 1-5 vdc a standard?

1 Answers   Process Control Technologies,

---

If range of 3-15 psi, a multiplying relay with a 1:2 ratio would give what output pressure for 6 psi input?

1 Answers  

---

---

what is the meaning of wet leg & where is it used?

1 Answers  

---

What is Difference between PLC and CNC ?

2 Answers  

---

radial & axial vibration sensor output voltage is ac or dc volt?

8 Answers   Vedanta, Voltech,

---

What are the interlocks we have to check during the start up of LP/HP compressor?

0 Answers   Hamsco,

---

why we take %i0.0 as input for twido plc

0 Answers  

---

can u please tell me the different types of valve uses and wt purposes it is used ~!(controlling the flow other than that which valve should be used in what place)

2 Answers  

---

WHAT IS THE MASS FLOW FLOW METER

4 Answers   Reliance,

---