Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to
form factor. What happen to 400KV and 765KV transmission
voltage?
No Answer is Posted For this Question
Be the First to Post Answer
Seamless tubes are made by?
nwhat are the main Components of servo motor?
What happend if we connect star point to ground of a star connected motor? And what will be effect on system and effeciency of motor?
Difference between DOL starter & star Delta Starter? And where the Dol starter used upto how much HP and whereas Star Delta vice versa?
What is the physical significance of phase.. i.e. what is exactly the meaning in layman's language.. 1 phase, 3 phase etc ???
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
What are the components ofan HT panel in a 11kv power station?
IN 3 PHASE INDUCTION MOTORS SOMETIMES COPPER BARS ARE PLACED DEEP IN ROTOR WHY..?
Difference between on line capacitor and Station type capacitor
I have 12MW gas engine based power plant its running parallel with grid. my problem is When cpp run in island mode(without geb) that time geb transformer power factor is 0.2 lagging. When cpp run with parallel that time power factor is 0.94 lagging So how can i maintain power factor ofgeb transformer in island mode 0.9 lagging?
When a fourth resistor is connected in series with three resistors, the total resistance
What is the name of the winding from which the supply is taken for load connections?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)