Answer / sandeep

not sure where the unknwn resistsnce is to be connected.
please give few steps for the answers.

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

0 Answers  

---

how to calculate current and voltage in a same circuit?

0 Answers  

---

what is mean by xlpe cables?

3 Answers  

---

What are the basic elements used for modeling mechanical rotational system?

0 Answers  

---

power inverter we are using 2n3773 power transister in that places we can use any IGBT ?

1 Answers   Essar,

---

What is the Diesel consumption between 82KVA DG Set and 180KVA DG Set for 1 hour.

1 Answers  

---

Difference between divercity and power factor

1 Answers  

---

I completed my BE EEE degree 2006 .... which license should i apply .... ?????

0 Answers   Real Estate,

---

what will happen if neutal in AC ckt will get open

3 Answers  

---

which network topology offers the greatest level of tolerance?

0 Answers  

---

What is the minimum underground tank size capacity considered for firefighting purpose?

0 Answers  

---

This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.

0 Answers  

---