Answer / rohan g

SMART sensor do have some additional accessories or you can
say features.such as additional communication
interface,selfdiagnostic features etc.Whereas sensors only
do the sensing job no any other features.

how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

0 Answers  

---

What is deffrence between Battery and capacitor

3 Answers   Siemens,

---

The DCS has the following signal type:

3 Answers  

---

if a tank is contaning oil and water than how can we measure the oil and water level seperately

3 Answers  

---

procedure to commission a drum level transmitter

1 Answers  

---

Identify and use the ANSI/ISA-S5.1 consensus industrial standard process symbols.

0 Answers   GAIL, Olympia,

---

During valve sizing from all calculation you got flow coefficient CV 12,than what it means? like for selecting pressure transmitter if your MAWP is 12 bar than you select a capsule of max. 20 bar which cover your mawp 12 in same way for selecting control valve If CV is 12 than how we use it in selecting valve??????

1 Answers  

---

What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?

0 Answers  

---

Why rtd  out put is ohm how create the ohm 

1 Answers   Samsung,

---

HI FRIENDS IHAVE QUESTION 1.WHAT IS PARTIALSTROKE TEST?WHY IT IS USED ON ESD ON OFF VALVES?

3 Answers   KNPC, Rotork,

---

Can anybody explain what is the different between ESD & PLC

1 Answers   ADCO,

---

hi all plz tell me difrence between analog or digital load cell.

2 Answers  

---