HOW TO CONVERT 0-60KG/CM2 PRESSURE TRANSMITTER TO A LEVEL TRANSMITTER? CAN WE A

HOW TO CONVERT 0-60KG/CM2 PRESSURE TRANSMITTER TO A LEVEL
TRANSMITTER? CAN WE ABLE TO DO IT? IF YES HOW TO DO IT BY
USING HART?

Question Posted / d.raghu86

3 Answers
9221 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

HOW TO CONVERT 0-60KG/CM2 PRESSURE TRANSMITTER TO A LEVEL TRANSMITTER? CAN WE ABLE TO DO IT? IF YES..

Answer / a.mondal

know that pressure=(hight x sp.density x g),where g and sp. density are constant so that pressure is proportionaly related to the hight or level.

Is This Answer Correct ?

12 Yes

1 No

HOW TO CONVERT 0-60KG/CM2 PRESSURE TRANSMITTER TO A LEVEL TRANSMITTER? CAN WE ABLE TO DO IT? IF YES..

Answer / santosh kumar

Yes it can be measured for level measurment by using
Pressure transmitter of 0-60kg/cm2. If the level measurment
for open tank with HART communicator convert into mmH2O and
feed the RANGE for level measurment(Tank heightXdensity of
liquid in Tank)

Is This Answer Correct ?

10 Yes

0 No

HOW TO CONVERT 0-60KG/CM2 PRESSURE TRANSMITTER TO A LEVEL TRANSMITTER? CAN WE ABLE TO DO IT? IF YES..

Answer / rohan

Nowadays transmitters are having inbuilt math processor having
program stored in its memory.So in this case

P=h*density*g

This will convert pressure into level.

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

can you send remote seal interface level transmitter calculation steps for oil water saperator.

0 Answers Sasol Firm, Thermax,

Which boiler is use in power plant

1 Answers Jindal,

basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......

0 Answers

Why some transmitter shows flow in MMWC and some in TPH?

2 Answers

why we are using ungrounded RTD sensor and what is difference between grounded RTD and Ungrounded?

1 Answers

how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.

0 Answers

what is seebeck effect?

7 Answers

how to overhaul control valves.what are the proper procedures.

1 Answers Jindal, QAFCO,

An equipment is certified for EEX, IA, IIC, T6, what do you under stand by this.

3 Answers ADMA OPCO,

In control valve , Failure position : Close If it is Fail close(FC) during failure of AIR.. what will be the initial/ normal position of control valve is it normally open or close? please some one explain soon..

2 Answers

Dear friends, I have a question: We work on a project which has some boilers to provide steam for desalination unit. The boiler area is safe and the only hazard source is the fuel lines of boilers. I want to know according to NFPA standard which type of instrument should be selected on the fuel line: Eex Type or Non-Eex type? Thanks in advance

2 Answers

What is smart positionar

2 Answers

For more Instrumentation Interview Questions Click Here