we all know that corona is nothing but ionization of air around the conductor a

we all know that corona is nothing but ionization of air around
the conductor and there by allowing current to pass through
ionized air.but we are not getting any short circuit in between
the respective phases though the air turned as a conductive media
between them??

Question Posted / raviteja.vaka

1 Answers
4400 Views
Siemens, I also Faced
E-Mail Answers

we all know that corona is nothing but ionization of air around the conductor and there by allowing..

Answer / raghavendran

In corona, the air around the conductor(phase) is ionized
and starts conducting.But the potential build up between any
two conductors is not higher than the break down strength of
insulation of air.The clearance between the two conductors
is designed keeping this fact is mind.Hence it do not get
short circuited.May be if the clearance is small, there
might be any possibility of Short circuit.

Is This Answer Correct ?

19 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why the conservater tank alwes made upper side of transformer???

3 Answers

why usa use 60hz and 110v?

2 Answers

how can we decide where we have to DYn11 or other vector group transformer

4 Answers BSL, Knight Frank, Security Printing and Minting Corporation of India Limited,

FRIENDS, I am doing DEEE (part time)final year. Give me some ideas for project

5 Answers HCL,

Define steady state error.

0 Answers

watt meter have 4 terminals what there name??? and what theses 4 terminals indicates ?? and why 2 terminals are short circuited??

1 Answers

can we run all LT motors at 360 volts which are normally rated 415+/-10% voltage rating

2 Answers Meinhardt,

An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.

0 Answers

I am having a DG set.The 415 V from Generator is step up to 460 v and then the same is used for Induction furnace. before Step up, I am connecting LT load to my factory use. When Induction furnace is in service from DG, when i try to start a motor, the generator is tripped.Please tell me the reason.

3 Answers

How to check VFD outgoing voltage

1 Answers

in dc machine airgap is there b\w stator and armature but by conduction emf is generated how & what is conduction

1 Answers

in the exciter the power is feeded from battry or control or whatever.and we need it in the generators for the stating . do we need it in the shutdown also?i mean the exciter>

2 Answers Shell,

For more Electrical Engineering Interview Questions Click Here