How can we check ELCB trip current sensitivity
How can we check earth resistance value
Answers were Sorted based on User's Feedback
Elcb is earth leakage circuit breaker. There are many
sensitivities in India. popular are 30ma, 100ma, 300ma,
500ma. For getting the correct corelation as to which
sensitivity is to be used for what application, it is
necessary to understand the effect of electric current on
the human being. I have the chart which shows the effect of
different ma current flowing through ones body and the
result. Usually below 30ma current is safe and gives only
tingling sensation to the person. But above 300ma can prove
dangerous and heart will stop.
For the second part you can use an earth megger and
connections are provided on any website or send me a mail
williamloboatrediffmaildotcom.
Is This Answer Correct ? | 20 Yes | 2 No |
Answer / sudhir patil
1] By using ELCB Tester
2] By using EARTH PIT
Is This Answer Correct ? | 7 Yes | 2 No |
what is the preventive @ predective maintenance
do we use neutral grounding for resistive balanced load? if we use what happen?
what is slip ring startor
if my load is not in continuous operation so what type of panel is required APFC or fixed capacitor bank without APFC whether C.T is required in both cases compulsory? explain detail
how to use single phase supply for a three phase equipement.
What are the tests carried out on transformer while testing at sites?..Pls explain me in detail
what is the working principle of ceiling fan and table fan?
10 Answers ABC, Tata Steel Limited,
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
can we use heat gun instead of gas torch in 11kv termination kit. I mean can both sources provide enough amount of heat to ensure the uniform shrinkage of sleeve.
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
why armature is placed in stator but not in rotor in synchronous generator ?
Can earth resistance be measured without connecting the earth electrode? and should earthing connections be disconnected What is the effect of connecting two cables of different sizes in parallel with supply? Thanks in Advance. I am intrested to get in touch with some tecnocrats/engineers,my mail i.d is : hiremathvijay@rediffmail.com