Interested to Buy Any Domain ? << Click Here >> for more details...
we all know that corona is nothing but ionization of air around
the conductor and there by allowing current to pass through
ionized air.but we are not getting any short circuit in between
the respective phases though the air turned as a conductive media
between them??
- 1 Answers
- 4225 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / raghavendran
In corona, the air around the conductor(phase) is ionized
and starts conducting.But the potential build up between any
two conductors is not higher than the break down strength of
insulation of air.The clearance between the two conductors
is designed keeping this fact is mind.Hence it do not get
short circuited.May be if the clearance is small, there
might be any possibility of Short circuit.
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
What's the difference between non break power supply and non break non short break power supply
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is the relation between frequency and motor rpm?
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
What are the three major categories of error?
A d.c. Shunt motor is found suitable to drive fans because they require?
How to decide DO set rating of Transformer?
What is your acheivements
Why does curving the pole faces in a dc machine contributes to a smoother dc output voltage from it?
Why air circuit breaker off due to power failure?
Who are the manufactures those manufacturing 3Cx2.5sqmm FRLS cables. I heard about FRLS technology adopted only in wires useful for wirings
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
pls tell me function of closing coil of A.C.B.
