Answer / bidu

inner part-carbon.
outer part-ceramic.

when u are given a timer,push buttons and contactor, how do i practically make a star delta control circuit and a direct online control circuit?

1 Answers  

---

Should power factor be low or high?

0 Answers  

---

1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?

0 Answers  

---

why earthing point in the 6amps/16amps socket bigger than the remaining (Phase & Neutral)points.

1 Answers  

---

what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV

0 Answers  

---

WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT

0 Answers   APGenco,

---

why do we generate sinusoidal ac?can we generate some other waveforms by alternators?

11 Answers   Siemens,

---

What core magnetic balance test of transformer? How to do this test in a three phase Star star (star-LV, star-HV) transformer? How to measure and where to measure?

1 Answers   Alstom,

---

All tape of electrical questions Answers tape of motor transformer e.o.t crane

0 Answers   Afcons, Honeywell, Manlift, SIMS,

---

what is the difference between CT and CVT in EHV Sub Stations

4 Answers   Hofincons, Lanco, TATA,

---

HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii) DELTA LOAD, USING A CLAMP METER. NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO WE GET?? PHASE CURRENT OR LINE CURRENT.

13 Answers   Bhel,

---

what are clipper and clamper circuits?

2 Answers  

---