how can we connect the capacitor bank to improve the power factor?

Categories >> Engineering >> Electrical Engineering
Suggest New Category

how can we connect the capacitor bank to improve the power
factor?

Question Posted / venki_shaju

5 Answers
10301 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how can we connect the capacitor bank to improve the power factor?..

Answer / rajnikanth

capacitor when connected in parallel improves the power factor

Is This Answer Correct ?

17 Yes

1 No

how can we connect the capacitor bank to improve the power factor?..

Answer / deepak

capacitor when connected in parallel to load improves the
power factor

Is This Answer Correct ?

9 Yes

1 No

how can we connect the capacitor bank to improve the power factor?..

Answer / prashant prajapati

U can connect Capacitor between Supply And Load ;;Before
load Connection connect capacitor ..it's effect improve
P.F....

Is This Answer Correct ?

6 Yes

2 No

how can we connect the capacitor bank to improve the power factor?..

Answer / naveed khan

Normally when capacitor bank is connected in parallel it act
as equipment that causes improving in PF. so should be
installed in parallel with load and supply.........

Is This Answer Correct ?

0 Yes

0 No

how can we connect the capacitor bank to improve the power factor?..

Answer / ranil gamage

no it connected to the befor the ATS Panel only City power
side,Genset not support to the Capacitive laod.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

what is DG synchronization panel plz explain the working!!!!!!!

12 Answers Kirloskar, Lanco, MPS Techologies, Sedemac,

how much current a 100 sq mm busbar will carry?

1 Answers ABB,

What are the complete specifications of a motor?.

2 Answers RRB,

why capacitor do not switch ON the DG power? (I had checked, capacitor ON in DG power that time current rating was reduced.)

1 Answers

how much earth resistance consider to commissioning the transformer?

3 Answers Deccan Cements,

why doesnt the back emf hold the speed of unloaded series motor?

1 Answers

avr is an automayic voltage regulator ... it regulates voltage before it synchronise with grid after synchronisation it regulates power factor why....

7 Answers

bit confused - am i correct in thinking that to determine line to line voltage in a star config 110v 3 phase 4 wire distribution system i would use a voltmeter? I have a circuit configured as an unbalanced load, consisting of three incandescent lamps (1x40w, 1x60w, 1x100w - all 110v rated)connected in a star configuration to a 110v 3 phase 4 wire distribution system. I want to find out what types of meters i would use to obtain: a) each line to line voltage b) the line to neutral voltage across each load c) current flowing in each line and load d) current flowing in the neutral conductor e) power supplied to the loads im assuming i would be using ammeters in series along each line and voltmeters in parallel across each line to neutral? Also how could i predict these meter readings before taking them and with which formulae? Any help would be greatly appreciated A.

1 Answers

What is the difference between EARTH & NEUTRAL?

13 Answers L&T,

To check the earth condition (In plug points); the voltage between earth and Neutral is in below 5 volts. Is it correct

6 Answers

What is the difference between Rectifier & Converter?

12 Answers Bajaj,

Why the transformers are rated in KVA. ? in new view.

2 Answers

For more Electrical Engineering Interview Questions Click Here