Answer / mojinkoshy

It depends up on the material of the Busbar.
ie. if you use cu bus bar (SWITCH BOARD current RATING / 1.2)= CU. busbar area. if you use Al. bus bar (Switch board current rating/ 0.8) = Al. busbar area.

the bus bar area is normally expressed as 50X6 or 2Nos. 100X12 not like 100sq.mm.

what is meant by VDC ?where its applicable ?

2 Answers  

---

if 50hz transformer is required to be run on 50% frequency what needs to be done???????????

6 Answers   century,

---

what is the write prosidure of stringing of 8meter pcc pole.

0 Answers  

---

why batteries are rated in ampere hour

1 Answers  

---

how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.

0 Answers  

---

As you achieve greater success with the company after some years, Will you like to be a share holder in our company?

0 Answers   PESPL,

---

What is the measuring instrument of magnetic flux density?

2 Answers   CSEB,

---

Why to keep capacitor bank off while generator running.

0 Answers   GIT,

---

slor cell made?

1 Answers  

---

How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).

0 Answers  

---

if transformer core is made of copper instead of steel which losses will increase..please explain

5 Answers   Bhel,

---

HOW TO CALCULATE THE WIRE SIZE FOR THE GIVEN LOAD?

5 Answers  

---