how to design a sheet metal bracket?
Answers were Sorted based on User's Feedback
Answer / gps
Designing a Bracket is a complex process. It involves a lot of considerations, that is if you want it engineered i.e. to save money and materials and addressing the issue. A very simple bracket can be made as explained by other users, but a custom engineered bracket requires includind space available, Material thickness, Ribs and enforcements in the structure, proper torsional rigidity and strength and minimum usage of the material. Sharp edges and corners should be avoided. Abrupt geometry changes should not be present. manufacturing ease should be taken into account. Ensure uniformity.
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / khanpara rushin.m
Just take a metal sheet as per thickness which are suitable as per its application and strengthen vs produced working stress during its real application , make
marking from where the sheet is to be folded, heat the area
by using gas cutter and bend at the marked area to 90
degree, you will get braket.
or
Mark the area by punch, cut it by punching oporation, finish it by rimming process and remove the burs,
grinder and finally make a weld by taking required shape
Is This Answer Correct ? | 4 Yes | 3 No |
Answer / sreenath
first we take a metal sheet, then make marks on it which
measurements are given, by using a marker, then cut through
the markings and fold the wanted bracket shape. fold it neatly
then we got a sheet metal bracket
Is This Answer Correct ? | 23 Yes | 24 No |
Answer / paresh khandla
take a metal sheet then mark with pencil on sheet metal and
cut shape as per dimension and then fold all side,
Is This Answer Correct ? | 7 Yes | 11 No |
Answer / kasiperumal kp
Select the dimensions of the metal sheet based the unfolded
length of the bracket dimensions. Mark the shearing line
and bend line based on the specifications given in the
bracket drawing. Then shear the unwanted area of the sheet
metal. With respect to the bendline, fold or bent the sheet
metal, to the required shape ans size.
Is This Answer Correct ? | 0 Yes | 4 No |
Answer / akshay
Just take a metal sheet with more than 5mm thickness, make
marking from where the sheet is to be folded, heat the area
by using gas cutter and bend at the marked area to 90
degree, you will get braket.
or
Mark the area by punch, cut it by gas cutter, finish it by
grinder and finally make a weld by taking required shape.
Is This Answer Correct ? | 1 Yes | 15 No |
Answer / guest
take meshrument what they required and cut it shape
Is This Answer Correct ? | 6 Yes | 23 No |
M.E.(produtio ) of full form
sir, I am applied RRB chennai,for Section engineer (mechanical),Pls mail 2007,2007 & 2008 years solved question papers.My Mail Id:nathan_cs65@yahoo.com Thanking you
What is the difference between heat capacity and specific heat of a material ?
what is the relation between f and reynolds number?
what is the jacking oil pressure of each bearing of steam turbine?
if you are standing on 30th floor & you asked to drink a water through straw .can you? water is in glass at the ground floor.
how we can check of any kitchen exhaust fan
What is the difference betwn a tube and a pipe .
What valves are fitted in a four-stroke diesel engine?
How do you calculate the area under the stress-strain curve?
How does a boat measure speed?
What is the purpose of stern tube?