Answer Posted / sreenath
first we take a metal sheet, then make marks on it which
measurements are given, by using a marker, then cut through
the markings and fold the wanted bracket shape. fold it neatly
then we got a sheet metal bracket
| Is This Answer Correct ? | 23 Yes | 24 No |
Post New Answer View All Answers
please send interview questions on foundry. my email id is m_vijaypanday@yahoo.co.in
What is the density of plastic?
What is the role of nitrogen in welding?
Tell us how do you discharge your duties in your duty post
What is control volume system?
There is a back compression in Engine, what does it mean
Explain the causes of the exhaust valve leakage.
How can I see where pipes are behind the wall?
what is the working principle of thrust pump in centrifugal chiller.
plese send me the rrb model questions for JE mechanical
Sir, In the current session I am attending the Junior Engineer Exam in Grade II for Mechanical Engineering. If it possible. Please sent the Past Exams Question on my mail. It is so useful use to me.
Explain the difference between “stress and strain”?
Why cad cam is better field against IT field?Is the salary is good in this field and if it so then what is the average salary in this field because I don;t think that salary is good enough in this field.
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
Are you ready to comply with the employment rules and regulations if your CV is considered for employment?
