Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / khanpara rushin.m
Just take a metal sheet as per thickness which are suitable as per its application and strengthen vs produced working stress during its real application , make
marking from where the sheet is to be folded, heat the area
by using gas cutter and bend at the marked area to 90
degree, you will get braket.
or
Mark the area by punch, cut it by punching oporation, finish it by rimming process and remove the burs,
grinder and finally make a weld by taking required shape
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
• What is your weakness?
What parameters to be reported when we send lubricating oil for shore analysis?
We have 6-axis wotan horizontal milling & boring machine. Linear axis- x,y,z,w & U. Rotary table B Axis Z,U & W axis are parallel. Z is tool axis. X is cross slide. We wish to retrofit the machine.Which control I should select & also suggest How many axis simutaneous control for linear & circular interpolation.
What is the specific heat of water?
Who invented the four-stroke engine?
What are materials used for manufacturing of gears ?
How does an equal-arm balance work?
"How to check the diode, fuse and bearer switch?"
sir, I am applied RRB chennai,for Section engineer (mechanical),Pls mail 2007,2007 & 2008 years solved question papers.My Mail Id:nathan_cs65@yahoo.com Thanking you
What are the procedures of starting of diesel engine?
What is the difference between blower and fan?
On what basis can sliding contact bearings be classified? Explain?
relate the frequency between feed water treatment & blow off
Which element causes difference in higher and lower heating values of fuel ?
What are the types of cleaning main engine Turbo Charger blower side?
