Answer / vikas mudhai

silent pole rotor-
1)used in low speed alternators(hydro-generator)
2)more no. of poles(4 to 64)
3)large diameter & small axial length

non-silent pole rotor-
1)used in high speed alternators(turbo-generator)
2)less no. of poles
3)small diameter & long axial length

Answer / k.prakashchandra

salient means most noticeable.So in salient pole rotor the
poles are seen distinctly and in the other type you don't
see the shape of the poles and the rotor has smooth surface

Answer / ramesh behera

Silent pole rotor-

1)large in diameter small in axial length
2)where flux density are high so lows speed alternators are
used for generating electrical energy.
3)Arrangement of large pole such to max 64
4) so these type pole rotors are used in hydro-generator

Non-silent pole rotor-
1)small in diameter large in axial length
2)Flux density appx. low high speed alternator are used
generating electrical energy.
3)No pole field are less appx.=4
4)so these type pole rotors are used in turbo-generator

In 110V DC supply,if a closed circuit gets open, How can we identify the voltage which is measured after the resistor(4KOhm) which is open with negative.it shows 55V +ve when measured, also the actual positive source is 55V +ve .Because there is no voltage drop in open circuit. How can we identify whether this is the voltage which is series with the resistor or the DC source direct +ve.

1 Answers   GE,

---

What is a signal flow graph?

0 Answers  

---

in case dc we mark as + ve & -ve..but in case a.c. we mark as ph&N...Y LIKE PLZ TELL ME

4 Answers   NPTC, TCS,

---

what is the function of short circuit maintenance ct and droop ct.

1 Answers   L&T,

---

why are you use the crgo core lamination in transformer

6 Answers  

---

how to calculate single phase motor efficiency ?

0 Answers   Bhel,

---

what is use of thermistor ?

2 Answers  

---

We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?

0 Answers  

---

How to calculate the cable size in sq. mm. when the load is given in KW?

1 Answers  

---

How do you know when the battery is fully charged?

6 Answers   ABB, Pricol,

---

why we used.c source in the field of the alternator , why not a.c source.

1 Answers  

---

the resstance of a thermistor is 5000 ohm at 25degreeC and coefficient is .04/degCel. A measurement with lead resitance of 10 ohm will cause an error of

1 Answers   GATE,

---