Interested to Buy Any Domain ? << Click Here >> for more details...
difference between silent and non silent pole rotor?
- 3 Answers
- 14178 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikas mudhai
silent pole rotor-
1)used in low speed alternators(hydro-generator)
2)more no. of poles(4 to 64)
3)large diameter & small axial length
non-silent pole rotor-
1)used in high speed alternators(turbo-generator)
2)less no. of poles
3)small diameter & long axial length
| Is This Answer Correct ? | 21 Yes | 1 No |
Post New Answer View All Answers
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
what is the importance of earthing system on the generators big capacity and small?
Why does amplifier gain reduce?
What is the purpose of stand by earth fault protection for transformer ?
How much earthing frequency is capable?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
What is the drawback of class b amplifier? How is this minimized?
how invertor convert the dc into ac give brif detail
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
why and how current drawn by battery charger depends upon the altitude where it is located?
How to operate a ac chilar plant?
how to select proper cable for ct wiring so that drop within the limit.
