why armature is placed in stator but not in rotor in
synchronous generator ?
Answers were Sorted based on User's Feedback
Answer / i.m.sayad.
To draw out generated voltage easily and economically than
using brushes,slip ring.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / n.j
Armature is not placed in rotor because of high cost of
insulation required to evacuate the power from the rotating
side.
Is This Answer Correct ? | 1 Yes | 1 No |
How cable from Kit-Kat to main switch, from starter to motor are designed?
TRAFO 1. WHY BREATHER IS USED. 2. WHY OIL GOES DOWN IN CONSERVATOR TANK. 3. WHY WE ARE TAKING OIL SAMPLE TAKING FROM BOTTOM OF TRANSFORMER. 4. HOW TO CHECK IR VALUE OF TRANSFORMER. 5. WHY OLTC HAVING BUCHHOLZ TRIP ONLY; WHY NO ALARM. 6. OFF LOAD TAP CHANGER OPERATION PROCEDURE. 7. TR. SHUTDOWN / ISOLATION PROCEDURE. 8. WHEN THREE TRS. IN PARALLEL, ONE TR. IS NOT SHARING THE LOAD – WHAT IS REASON AND WHAT YOU WILL DO. 9. WHY TR. HAS OLTC IN HV SIDE. 10. WHAT IS % IMPEDANCE. 11. WHY TR. RATING IN MVA. 12. WHAT IS VECTOR GROUP IN TR. 13. CONDITION FOR PARALLEL OPERATION OF TRS. 14. WHAT IS TERTIARY WINDING. WHERE IT WILL BE. 15. IF TR. TRIP ON BUCHHOLZ OR TAP CHANGER RELAY, WHAT YOU WILL DO. 16. DIFFERENCE BETWEEN OIL TEMP. AND WINDING TEMP. PROTECTION 17. HOW WINDING TEMP. IS MEASURED IN CAST RESIN TR. 18. DIFFERENT TYPES OF FAULTS IN TR. Trafo - Page-1 of 2 19. WHAT HAPPENS WHEN TR. CHARGED FROM LV. 20. WHAT WILL YOU DO IF MEGGER READING SHOWS ZERO BETWEEN LV WINDING AND EARTH. 21. CAN WE INTERCHANGE BUCHHOLZ RELAY OF MAIN TANK AND OLTC TANK. 22. IF THE LINE BETWEEN BREATHER AND CONSERVATOR TANK 23. LOCKED, WHAT WILL HAPPEN DURING LOAD CYCLE. 24. WHAT IS THE FUNCTION OF OIL SEAL IN BREATHER. 25. WHAT ARE LOCATIONS FOR BUCHHOLZ RELAY FIXED IN POWER TR. 26. WHAT ARE CHECKS IN POWER TR. DURING MAINTENANCE. 27. WHAT IS IMPORTANT WHEN WE CHECK OLTC OPERATION DURING MAINTENANCE. Trafo - Page 2 of 2
How 48-relay (incomplete sequence) functions?
how to calculate the no load current in transformer?
In Railway,why we are used HT Line 25KV ?.why we are not used 11KV,33KV and others for This?
37 Answers Airtel, BSNL, RRB,
why we are using in reverse power relay in generator singranizing
How many methods to take IR value of Current Transformer?
can the measured percentage error during calibration of single phase energy meter be negative?
how wud i know that whether i have to use unitized package substation or transformer?
After synchronization with grid how to maintain the power factor in lagging or in leading? if lead of lag what is the problem?
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
what is the synchronous timer ? and it applications.