Interested to Buy Any Domain ? << Click Here >> for more details...
how to testing the AC 3 phase motor? and what is the test procedure & kits required for testing?
- 3 Answers
- 8350 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil guru
HERE IS THE RIGHT ANSWER......
1.TYPE TEST
2.ROUTINE TEST
OTHER TEST FOLLOWS AS UNDER
1.MEASUREMENT OF STATOR AND ROTOR RESISTANCE
2.NO LOAD TEST
3.OVER LOAD TEST
4.TEMPERATURE RAISE TST
5.HIGH VOL. TST
6.INSULATION RESISTANCE TST
7.FULL LOAD TST
8.REDUCED VOLTAGE RUNNING UP TST
9.LOCKED ROTOR TEST
10.BLOCK ROTOR TEST
11.MOMENTURLY OVER VOLTAGE TEST
IF DISAGREED THEN MAIL ME AT parmar20072008@yahoo.com
I WIL C THAT.............
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
are there rmu for 3 transformer?
What is the BS(British Standard)code for 11kv motor
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
how we design a pannel to start 10HP motor with the help of star delta starter?
how wecalculate breaking capcity of acb mcb mccb .explain with example
earth also having a gravitational force (magnetic field of north and south)but it attracts any object compare to this theartifical magnetic cant perform same as earth why?
Hi,iam a diploma in electrical engineering.rtd from indian air force in apr 2007.prsently working in reliance next link as a network maintenance engineer since 2007,can i get a job in motherson sumi.
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
PAC and simple Ac different
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
What is sink and source?
How cable from Kit-Kat to main switch, from starter to motor are designed?
what is meant by 2 within a star in a voltmeter dial?
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
