Answer / kapil narayanrao bahadure

The working principle of ceiling fan:-ceiling fan in which
split phase motor. It is work on mutual induction.
The working principle of table fan:-table fan has a split
phase motor.& also work on mutual induction.
mutual induction:-when stater connect on ac supply,stater
produced rotating magnetic flux.this flux cut with rotar.by
air gap.& produced rotating magnetic flux in it.

Answer / kanhaiya sharma

it is work on the single phase induction capacitor motor

Answer / poo zhey

ceiling fan works by the principle of induction. i.e. when
ac supply is given to a coil, rotating magnetic flux is
produced which is induces voltage in the rotor and develops
torque. thus it rotates

Answer / a.ashraif

ceiling fan , table fan works on the priciple of mutual
induction

Answer / shivkumar

The working principle of ceiling fan:-ceiling fan in which
split phase motor. It is work on mutual induction.
The working principle of table fan:-table fan has a split
phase motor.& also work on mutual induction.
mutual induction:-when stater connect on ac supply,stater
produced rotating magnetic flux.this flux cut with rotar.by
air gap.& produced rotating magnetic flux in it.

Answer / sama

both fan are working on the principle of electromagnetic induction,but in ceiling fan coils are rotating and in table fan coils are stationary.

Answer / anbarasandurairaj

Ceiling fan and table fan are workinhg by self induced emf

Answer / mr.hits

cieling fan is rotating on the upper wall and the table fan can be rotated anywhere

Answer / b.sivayya

celing fans are maximum single phase capasitor type of
motors

Answer / richa jha

In the operation of an AC motor, the frequency of the applied power determines the motor’s speed and the voltage determines the motor’s torque capability. The torque capability is actually defined by a curve showing torque capibility vs. operating speed.The induction motor runs at a slip depending upon the load. The slip is rarely more than 10%. In any case from the formula N =120F/P where N is the synchronous RPM, F the frequency, & P the number of poles , it can be seen that voltage has no role in the speed control. There is some other reason

In winter we seem lightly an electric shock when we touch to doors(sometime)

13 Answers   Infosys, REL,

1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?

0 Answers  

what happend if the protection ct is by mistake put instead of measuring ct & vice versa?

2 Answers  

what is ac servomotor??

7 Answers  

Can earth resistance be measured without connecting the earth electrode? and should earthing connections be disconnected What is the effect of connecting two cables of different sizes in parallel with supply? Thanks in Advance. I am intrested to get in touch with some tecnocrats/engineers,my mail i.d is : hiremathvijay@rediffmail.com

1 Answers  

what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????

0 Answers   ABB,

why it is important to earth neutral of 3 phase transformer?

9 Answers   IBM, ITC Indian Tobacco Company, RRB, UDS,

What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB

0 Answers  

OUR METER READER TAKE READING OF INDUSTRIAL CONSUMER.THEY ALWAYS ASK HOW TO INCREASE POWER FACTOR FROM 60% TO 99 % TO AVOID PENALTY OF POWER FACTOR.

3 Answers  

State four advantages of hydro power station over nuclear power station.

1 Answers  

Why distribution transformer secondary voltage is 0.433kV instead of 0.415kV.all other switchgear rating are 415 volt??

3 Answers  

What is neutral and how to produced

1 Answers   L&T,