why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
1950what is the relation between the size of the machine and the frequency? (when the frequency increases the size of machine will increase,why?)
2 5091can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
2049Post New Electrical Engineering Questions
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
What is the function of Governor in Hydro Power Station? What is the Function of Lightning Arrestor Voltage Transformer (LAVT)?
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
Can we put 3 layers of cable tray while installing tray
State magnitude criterion.
If not into production, how far did you follow the design and why did not you see it into production?
how to calculate magnetic force genrated by a coil ?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
what & how to check the lightning arrester
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?