What will happen if i connect two 3-phase tranformers secondary supply on one bus bar that is R-Y-B-N?
GMR,
2 4731What is difference between Dy11 & Dyn11 vector group transformer. Can both these transformers operate in parrallel.
5 64661what is the relation between KVAR,KVA,KW?why we are mentioning capcitor rating in kvar?what is meant by arcing horn and horn gap in transformer?what is equipotential wire?
1 6876What is the method to calculate the capacitor bank rating for say 50 KW load and how do we connect each capacitor to busbar??
4 13433In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
HAL,
2123Post New Electrical Engineering Questions
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
Any Electrical Engineering jobs?Please refer for interviews. Thank you
how can we calculate the ratio of caustic soda and water in lrs.
what is value of Jin transformer
Explain about Leakage Test.
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
briefly explain the main blocks found in a microprocessor based system
What test must you do before powering up a circuit that you have been working on?
What is s-domain and its significance?
Motor,transformers,capacitor tubelight etc....
how to find impedance , mutual indatnce in transmission lines
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
what is the sludge current