If Two Generators are working parellel in a network and suddenly the field of one Generator get weakened What will happened if there is no reverse power relay fixed in that Generator panel????
7 10765In which reason, one end of CT secondry get connected with Earthed? Normaly S1 of CT. Why????
1 5768If we feed 230V ac supply to a full wave rectifare, what & how much will be the out put voltage?
3 6242What is harmonics in AC waves. How it is generated? How it will effect the system network? how can eliminate it?
2 5126HI, I want to buy a new Xformer to my plant. what are the main parameter should I check ( Xformer rating is 16 MVA)
2 4361Post New Electrical Engineering Questions
I want single line diagram for AMF & DG syncronizing panel
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
Difference between transition and diffusion capacitance
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
Cb closed condition if there is a tcs fail whether cb will trip or not
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Difference between a pilot wire and a normal conductor?
Which type of questions well asked. ?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
can we install HT panel & LT panel side by side or how much clearance is required ?
What are the basic component of a cro?
we have a rewind motor of 2Hp,2800Rpm, 220Volt AC. how can we choose the running capacitor for this motor, any formula for that?
Who many reason of ignition fail ?
What are the difference between normal application Transformer and Solar application Transformer?