what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
1661WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
1580what are the standard values for resistances(Megger testing) between L&N, L&E and N&E (L=Live,N=Neutral, E=Earth)?
CESU,
1 2484what are the standard values for resistances(Megger testing) between L&N, L&E and N&E (L=Live,N=Neutral, E=Earth)?
1 9087Why we are going for converter transformers for DC drives application instead of distribution transformer?
1442Post New Electrical Engineering Questions
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
Keywords: Die, Card, Coin, B/N 2 To 12
how to calculation increase power factor for single phase
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
how to calculate the no load current in transformer?
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
what is th basic difference between a d latch time line and a d flip flop time line???
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
what is the difference between unarmoured & Flexible cable? How to identified?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
why and where we use early make & late break contacts in protection?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
What are the classifications of oscillators?
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?