What is the maximun current carring capacity in per phase for three pole 100anps rating ncb
L&T,
3 8500I am having dual speed motor of cromton greaves make of 3.7 KW -1400 rpm and 5 KW - 900 rpm. Please let me know groups and winding connction for rewinding purpose.
1922what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
2398what are the effects on an power plant and consumers if the power factor is increased or decreased?
2 4713in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
2087why in electric train we can't feel current & generally we have get socked in our normal electricity ?
3 5872what is the diffrence between dol and star delta strater? why star delta starter used instead of dol?
3 9606Post New Electrical Engineering Questions
How out of step protection relay works?
What is meant by RVT and NDR ? expansion and details of it
what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?
What is center gravity load in substation?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
Difference between HRG and NGR. Are they both the same thing
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
how we find transformer capacity by ohm
What is the distance between each insulator in 33kv transformer and how can it calculate
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
How energy is generated in hydroelectric power plant?
What is different between resistance grounding system and resistance earthing system?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
which type of amplifiers are used in multimete?
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?