Mechanical Engineering Interview Questions, Answers for Freshers and Experienced asked in various Company Job Interviews

Mechanical Engineering Interview Questions

Questions Answers Views Company eMail

IN THERMAL POWER PLANT WHY WE ARE USING SINGLE SHAFT FOR THE COUPLING OF HP,IP&LOW PRESSURE TURBINES....WE CAN USE INDIVIDUAL SHAFT FOR EACH TURBINE....?

2 6555

In volute casing the discharge area is more. so as per bernoulli's principle the pressure must be reduces also from the basics, pressure = Force/Area. so pressure and area are inversily proportional. By considering these two basic rules pressure must be reduces. But in any centrifugal pump, the pressure is increasing. How the velocity is converted into pressure. In my view only head is increases but how the pressure increases?

2 6843

In orifice why the pressure and temperature are decreases?

14 17566

what is mechanical engineering?

6 10335

Sir can u send the Transocean written test paper format or interview questions?

TransOcean,

1 5960

Pls send me the 10 years technical question paper of Jindal steel power to my email id

Jindal, Jindal Steel and Power, Tata Steel Limited,

12 19744

What is the diffrence between four strock and two strock ic engine

Alkem Labs, Mechanical,

14 24193

pls, send me jindal steels & power aptitude ques

1951

pls ,send me technical questions of jindal steels and power ltd

Jindal,

2315

which type of changes observed in drum level during rising in steam load of boiler?

2 4901

what is strain

NHPC,

12 16201

what is stress

8 10798

how the velocity of the liquid is converted into pressure energy in a volute casing? finally we are getting high velocity or high pressure?

Satyam,

3 8490

Please mail me the Satyam Computers (Mechanical Division, Satyam Technologies, Hyderabad & Bangalore) question papers on Design & strength of materials. Will be very thanksful.....srinivas_1704@yahoo.co.in

Satyam,

2066

plz sent me jindal placement papers in mechanical enginnering

Jindal,

2840

Post New Mechanical Engineering Questions

Un-Answered Questions { Mechanical Engineering }

What can be reasons for a metal gas-kit to leak?

1554

CAN SOMEONE GIVE ME THE LINE DIAGRAM OF A VAPOUR ABSORPTION SYSTEM (VAM)(AIRCONDITIONING)AND A 600 TON CENTRICUGAL AIRCONDITIONING PLANT.

2211

will I find the mechanical engineering interview question for asian paints?

1560

What are the safety devices of boiler?

2103

i want to know the difference between proportional hydraulic valve & servo hydraulic valve

2236

what is the required force to bend 2.5 MS sheet in 90 degrees and what is the formula to calculate the same?

2756

How much pressure on air reservoir?

1987

What is the purpose of turning gear

2143

Re: what is different between run out and concentricity in Gd &T

2130

for -50 dec which grade steel can be used for ducting work?

1660

workingh principle of valve timing chart for cummins engine

2661

RRB exam qustions.

2159

What will be expected the cut-off of J.E Mechanical exam of RRB on 19/12/2010 ?

2190

What is ferrite?

1358

Is it required slip & guide for incliened pipe installation to allow axial expansion. If yes, what type we have to use it

1955

For More Un-Answered { Mechanical Engineering } Questions Click Here