Answer / raaaju

the force of resistance per unit area,offered by a body
against deformation........

Answer / nagarajan.b

stress is a measure of the internal forces acting within a
deformable body.
Quantitatively, it is a measure of the average force per
unit area of a surface within the body on which internal
forces act.
These internal forces are a reaction to external forces
applied on the body. Because the loaded deformable body is
assumed to behave as a continuum, these internal forces are
distributed continuously within the volume of the material
body, and result in deformation of the body's shape.
Beyond certain limits of material strength, this can lead
to a permanent shape change or physical failure.

Answer / nantha

Stress = Load/Area

Answer / anil kamat

It is not the force of resistance but resistance of force
per unit area,offered by a body against deformation........

Answer / arunraj

stress = load/area

Answer / kottairaj

Stress is nothing but force per unit area......unit of the
stress is N/m2

Answer / kashif haider naqvi

streses are those forces which are produced inside the
body ,wthin molecules,due to external loading.

kashif haider
EC,PAK

Answer / manjunatha

load acting per unit area .N/m2

How Trains take turns, though there is no any differential

6 Answers   Bosch, L&T, NTPC, RRB,

What is an ortographic drawing?

0 Answers  

what is cswip?

2 Answers  

Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.

0 Answers   ONGC, TATA,

How do you control cylinder liner wear?

1 Answers  

tansen was singer in whose mugal emperor

3 Answers   Concor,

what is difference between british wire guage & birmingham wire guage

0 Answers  

What is the purpose of starting air?

0 Answers   RRB,

WHAT IS THE DIFFERENCE BETWEEN IMPACT FORCE & SUDDEN FORCE.TELL ME WITH EXAMPLE IF YOU KNOW

2 Answers  

When we are C Check servicing the DG why we are changing strip sealing.

0 Answers  

Is There Any guy give me detail information regarding "ISO/TS-16949-2002 " /TPM/QMS/SPC/MSA ???

3 Answers  

What causes hardness in steel ? How heat treatment alters properties of steel ?

0 Answers