Interested to Buy Any Domain ? << Click Here >> for more details...
What is an EN Material. What is the difference of EN8, EN24, EN40.
Aeronautical Society of India, Ecil, Finearc, Saint Gobain, Scitech Centre, Universal Engineering Works,
5 85900When Centrifugal compressor is a non positive displacement compressor how it goes under surge due high discharge pressure when the discharge valve partially or fully clossed. please explain me clearly
2 8232HOW TO CALCULTE THE TR CAPACITY FOR SCREW COMPRESSOR, RECIPROCATING COMPRESSOR,PHE & COOLING TOWER? HOW TO CALCULATE THE FLOW RATING OF PUMPS?
3857WHAT IS FORMULAE TO FIND THE TR CALCULATION FOR THE SCREW COMPRESSOR,RECIPROCATION COMPRESSOR,PHE CHILLER,COOLING UNIT COIL& COOLING TOWER? PLEASE SEND ME STEP BY STEP
1 13832HOW THE POWER INTERMEDIATE WITH TON OF REFRIGERATION(TR) COMPRESSORS ? HOW THE POWER IMPORTANCE TO COMPRESSOR FOR THE LOAD ?
2 11776we have read that when the piston goes up and down then the engine works i.e. the suction,compression etc etc. then what happens in the case of big vehicles, which start at stable condition, i.e. how does their piston moves when they are at rest. how suction,compression etc
Bhel,
5 7793Post New Mechanical Engineering Questions
please sent last five years junior engineer mechnical question pappers
what is milling and types of milling?what is drilling and types of drilling? what is tapering and their types?
what is natural frequency & how to find it?
What is meant by parallel flow heat exchanger?
In Turbine how the balence piston works and what is the direction of leak of steam flow.
sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
If you want to provide water or any chemical @ 50 meter height how much head will you prefer for any selected pump...consider it is M.S pipings...how much friction loss will be there...show with calculation.
Why rate of condensation is higher on a polished surface compared to rusty surface ?
What is raito of coolent level in DG
Who built the tr alaska pipelene?
please briefly explain the Discharge process and Formula of Centrifugal Pump
Why head of a centrifugal pump is independent of density of fluid?.
Distinguish between the shear center and elastic center.
How many types of oil spilling available?
